EN
How To Fill You Bladder Accumulator:
Here is how to properly charge your bladder accumulator:
First release any accumulated pressure in the accumulator by bleeding the system.
Then, attach the charging kit to the gas valve on the accumulator and tighten everything up.
Gradually introduce a gas, such as nitrogen, into the accumulator to the desired pressure.
When the desired pressure is achieved, unhook the charging kit and monitor for leaks.
Lastly, write the last date you charged the accumulator on the outside so you can remember when you did it.
Maintenance Advice for Your Accumulator:
To keep your bladder accumulator in service for a long time, care for it according to the following collection of maintenance suggestions:
Monitor their pressure levels frequently to ensure they are fine.
Inspect for leaks or damage, such as cracks or bumps on the bladder.
2Make sure the accumulator is clean and not contaminated with grit.
Adhere to the manufacturer’s care instructions.
If you notice anything amiss, fix it fast to head off bigger problems.
Why Pressure Levels Matter:
Maintaining the correct pressure is critical to the proper operation of your bladder accumulator. Without the right amount of pressure, the accumulator won’t store and release hydraulic fluid correctly. Incorrect pressure can result in issues like poor efficiency, overheating, or damage. You can extend the life of your accumulator and prevent costly repairs by monitoring and inflating it, as necessary.
Service Guide to Here are general steps for repairing some of the most common problems in bladder-type accumulators:
If there is a problem with your bladder accumulator, here are some of the common problems and how you can fix them:
Loss of Pressure: Look for leaks and replace any damaged parts. Reload the accumulator at the proper pressure.
Excessive Noise:This could mean there is air or dirt in the system. Purge to eliminate the air or any impurity in the system.
Bladder Connection: If the bladder is ruptured or leaking, you will need to install a new one. You can do this by following the manufacturer’s instructions.
Sluggish: Inspect the system for restrictions. Clean out clogged parts or replace them so that it functions better.
Charging The Following is a Step-by-Step Process for Charging Your Accumulator:
Prepare the charging kit and check that everything is firmly in place.
Bleed the system to release any pressure from the accumulator.
Attach the charging kit to the gas valve on the accumulator.
Gas should be added slowly until reaching the proper pressure.
Remove the charging kit and inspect for leaks.
For the record, date the accumulator with the date of last charge.
Just watch your pressure levels and recharge when necessary to keep things going smoothly.
By doing so, Bladder Accumulator you can maintain the best shape of the bladder accumulator. Just keep in mind that the main thing is to take care of and charge your hydraulic system properly. Trust in HONGDA for all your hydraulic needs and we’ll take your equipment down smoothly.
